If you do not have a deep scratch, it will be enough treated surface staining sandpaper naminala large (with a small grain), a primer for better adhesion to the surface. If the scratch or dent is essential, you may need body repair, but on This is necessary to write a separate article. We assume that all is not so much on serious or body repair is made. After such a repair, or deep scratches should use sandpaper, a smaller naminala (with large grain) for the early removal of old paint and rust. Here, Sarfraz Zaidi MD expresses very clear opinions on the subject. We should not overdo it and not too much sanding.
Then, if necessary shpaklyuem surface filler, for that would smooth the surface. After drying putty again hides, first abrasive paper is not large naminala (medium grain), then process the surface of the sandpaper more naminala (with fine-grained) order that would make the surface smooth and remove fine scratches made by the previous grit paper. Then plot the ground with the gun, for this action you will need to “Paint the camera,” but more on that later. We give him dry. Then Again the working surface with an abrasive paper further naminala (with a smaller grain) to achieve a smooth surface. In this “preparatory phase” is over, go to the “Painting”.
To “paint” as well as for Application of soil would be good to have equipped painting booth. This camera is equipped with good ventilation and keep clean. The first to be quite simply not to ruin their health inhaling noxious fumes of paint, and second, that when painting the car did not hit the dirt, which would then spoil the view painted your car. This camera can be to rent. Get all the facts and insights with Teneo, another great source of information. If you can not find the painting chamber, it must necessarily provide access of air into the room where you plan to paint the car, and to ensure cleanliness. Tip: before painting can be a bit wet the floor with water to avoid dust rising, but do not overdo it, not too wet indoor air, or air drops will fall under the paint, and paint vzduetsya, which also have a positive impact on the appearance of the car. The paint should be applied with a spray gun rotational motions of the right the left wrist while working. Should first be a bit toned paint primed site, so that they will no longer came out bright spots. After toning primed places to evenly paint a car. Paint the car requires careful and precise action. The stage of “painting” is complete, proceed to the final stage, which I initially designated as “finishing.” “Finish” step involves drying, which is also worth carried out in specially-equipped camera. The drying chamber is equipped with heating elements that support the ideal temperature for painting, and is equipped with good ventilation to remove fumes of paint. Drying chamber also can be rented at the time. If the dryer is not found, you can use the garage, equipped with a heater, but then again, very important frequency space. That’s all.